Specification Sheet

E-Vision Laser 5000 WUXGA

5,000 ANSI / 5,500 ISO Lumens | Contrast Ratio: 20,000:1 (Dynamic Black) | Part Number: 118-568

Colour System:

DMD Specification:

Laser Phosphor

Display Type:

1 x 0.67" DarkChip™ DMD™

1920 x 1200 pixels native resolution.
Fast transit pixels for smooth greyscale and improved contrast.
Aspect Ratio:
16x10
Fill Factor

Key Features

Video & Graphics Processing

HDMI 1.4a for Side by Side, Frame Packing, Frame Sequential & Top Bottom 3D formats.

Synchronisation of active 3D glasses.

DICOM simulation mode.

Mobile High-Definition Link (MHL™) connection allows mirrored content from smartphones, tablets and other portable consumer electronics devices.

Geometry Correction

Vertical & Horizontal Keystone correction (2D: Vertical ±30°, Horizontal±30°).

Four Corner adjustment.

Selectable 16:9, 4:3, Native, Letterbox and Full Screen aspect ratios.

Digital Zoom +10~-10.

HDBaseT® Interface

Built in support for transmission of uncompressed High Definition Video over standard CAT5e/6 LAN cable.

Allows the projector to be placed up to 100m from the source with low cost cabling.

HDBaseT® includes audio, Ethernet 100BaseT and RS232/IR control.

Colour Processing

2 x speed, 3 Segment (GBY) Phosphor wheel.

2 x 120Hz speed, 4 Segment (RGBY) Colour wheel.

10-bit colour display.

55% of NTSC colour gamut.

Source Compatibility:

Graphics standards up to 1920 x 1200 resolution at 60Hz.
Horizontal frequency 15, 31 ~ 102kHz.
Vertical frequency 24 ~ 30Hz, 47 ~ 120Hz.

Inputs/Outputs

Video & Computer
Type	Connector	Qty
HDMI 1.4a HDMI 1.4a + MHL VGA / Analog RGB VGA / Monitor Out Composite Video HDBaseT USB Type A / (5V/1.5A) NOTE: The USB is to power WHDI™ interfaces. Audio: Audio IN L+R Audio IN L+R Mic IN Audio OUT (variable) Speakers	HDMI HDMI 15-pin D-Sub 15-pin D-Sub RCA 8P8C (RJ45) USB Type A Phono 3.5 mm jack 3.5 mm jack 3.5 mm jack 5W speaker	2 1 1 1 1 1 1 2 1 1 1 2

Communication & Control
Type	Connector	Qty
LAN RS-232C USB (for Service) 3D Sync Out NOTE: The HDBaseT and LAN ports are not shared.	8P8C (RJ45) 9-pin D-sub Mini B VESA 3-PIN mini DIN	1 1 1 1

3D Formats Supported	HDTV Formats Supported
Frame Packing HQFS \ Frame Sequential Side By Side (half) Top and Bottom	1080p (24Hz, 25Hz, 30Hz, 50Hz, 60Hz),1080i (50Hz, 60Hz), 720p (50, 60Hz)
Computer Compatibility	Bandwidth
VGA, SVGA, XGA, SXGA, SXGA+, UXGA, WUXGA@60hz, Mac	165 MHz on analog RGB 165 Megapixels per second on HDMI
Remote Control	Automation Control
IR remote control, 2 x IR receivers (front sensitivity up to 7m, rear sensitivity up to 10m)	LAN control - Crestron RoomView® Connected LAN control - Crestron eControl LAN control - Extron LAN control - AMX SSDP LAN control to RS232 by Telnet Concurrence Control for RS232/LAN HDBaseT communication Projector status email alerts
Colour Temperature	Operation
Warm / Normal / Cold
illumination Type	Typical illumination Life
Laser Light Source	20,000 hours

Lenses
Lens	Part No.	Optimised Focus Range*	Lens Shift
1.15 - 1.90 :1 zoom	N/A	1.5m - 5.0m	Vert: Fixed Offset 0.575 (U) frame + small variable shift. See User manual. Hor: 0.05(L) 0.05 (R) frame

* Lens focal ranges above are the optimised distances but are likely to focus further, please contact your RSM for more details.

Lens Mount
Manual zoom and focus with horizontal and vertical shift.

Mechanical Mounting	Orientation
Front/Rear Front/Rear Ceiling Two adjustable front feet, 10° (43mm) Ceiling Mount compatible chassis with 7 off M4 mounting holes available, maximum screw length 8mm (0.31")	Table Top or Inverted: Yes Pointing Up: Yes Pointing Down: Yes Roll (Portrait): Yes
Power Requirements	Power Consumption
100-240VAC 50/60Hz single phase	Normal Mode (100%) 440W @230V 460W @110V Eco Mode (80%) 340W @230V 360W @110V Dimmy Mode (40%) 190W @230V 200W @110V Standby, LAN enabled <2W @230V or 110V Standby, LAN disabled <0.5W @230V or 110VW
Thermal Dissipation	Fan Noise
Normal Mode (typical): 1570 BTU/Hour @ 110VAC 1501 BTU/Hour @ 230VAC BTU/Hour	Normal Mode Typ: 36 dBA / Max: 38 dBA Eco Mode Support Typ: 34 dBA / Max: 36 dBA Eco Plus Mode Typ: 34 dBA / Max: 36 dBA Dimmy Mode Typ: 29 dBA / Max: 31 dBA Extreme Dimmy Mode Typ: 29 dBA / Max: 31 dBA
Operating/Storage Temperature	Operating Humidity
Operating: 0° to 40°C (32F to 104F) Storage: -20° to 60°C (-4F to 140F) Altitude: 2,500ft to 5,500ft at a maximum of 30°C (86F) Altitude: 5,500ft to 10,000ft at a maximum of 25°C (77F)	10 to 85% non-condensing
Weight (Chassis Only)	Dimensions
10.7 kg 23.6 lb	L: 45.0 cm W: 35.0 cm H: 15.1 cm L: 17.7 in W: 13.8 in H: 5.9 in
Safety & EMC Regulations
UL/cUL, CB, CCC/CECP, FCC Class B, FDA, CE IEC 60825-1:2007 3R IEC60825-1:2014 Class 1 IEC EN 62471-5 Risk Group 2

Accessories
Accessory	Part No.
Infrared Remote (replacement)	118-678

*Dimensions included for reference only and are subject to change. Please download the full set of CAD files for this display for more accurate information.

Specifications subject to change without notice. ©2018 Digital Projection.
DLP®, Digital Light Processing™ and DMD are trademarks of Texas Instruments, Inc